TITANIUM ANODIZING RACKS? Why is this material, which is so much costlier than aluminum used in anodizing?
The answers are simple:
1. Aluminum racks are consumable.Anodic film builds up, necessitating stripping.
2. Titaniumracksareconsistent from run to run.
3. Titaniumracksdon’tanodize as do aluminum racks. Therefore, you can use your rectifier to anodize parts, not racks.
4. The higher initial cost of titanium racks is more than offset by the in-process savings, better consistency and longer life advantages of titanium.
5. Aboveall,ourtitaniumracks carry Servi-Sure quality and thought-through engineering into your tanks. The value of having Servi-Sure racks on the job will be realized again and again, in your anodizing.
Anodizing Racks
Below are disc configurations. Please contact us with your requirements for titanium Racks, anodizing clips, anodizing discs, fasteners, splines and collars.
“D” STYLE DISC (D Disc (1))
STANDARD NOTCHED TIP DISC
• AVAILABLE IN 0.050” AND 0.060” MATERIAL THICKNESS WITH 20 AND 30 STATIONS.
• SPRING LIMITER AVAILABLE TO PREVENT OVER BENDING OF FINGERS DURING RACKING.
• 8 1/4” DIAMETER
“DS” STYLE DISC (DS Disc (1))
STANDARD NOTCHED TIP DISC
• AVAILABLE IN 0.050” AND 0.060” MATERIAL THICKNESS WITH 20 AND 30 STATIONS.
• 8 1/4” DIAMETER
“DX” STYLE DISC (DX Disc)
STANDARD RIGID BOTTOM DISC
• AVAILABLE IN 0.125” MATERIAL THICKNESS WITH 20, 30, AND 60 NOTCHES AVAILABLE.
• SPECIFY IF USING DX DISC WITH OUR D‐DISC OR DP‐DISC.
“DP” STYLE DISC (DP Disc (1))
STANDARD PERMA‐FLEX DISC
• AVAILABLE IN 0.050” AND 0.060” MATERIAL THICKNESS WITH 20, 30, AND 40 STATIONS.
• SPRING LIMITER AVAILABLE TO PREVENT OVER BENDING OF FINGERS DURING RACKING.
• 8 7/8” DIAMETER
“DP‐R1” STYLE DISC (DP-R1 Disc)
STANDARD PERMA‐FLEX DISC WITH POINTED FINGER TIP
• AVAILABLE IN 0.050” AND 0.060” MATERIAL THICKNESS WITH 20, 30, AND 40 STATIONS.
• SPRING LIMITER AVAILABLE TO PREVENT OVER BENDING OF FINGERS DURING RACKING.
• 8 7/8” DIAMETER
“DTL” STYLE DISC (DTL Disc)
STANDARD TAPER TIP DISC
• AVAILABLE IN 0.032” MATERIAL THICKNESS WITH 10, 20, AND 30 STATIONS.
“DF” STYLE DISC W/ SLOTTED FINGER (DF Disc)
STANDARD FLAT SLOTTED FINGER DISC
• AVAILABLE IN 0.050” AND 0.060” MATERIAL THICKNESS WITH 30 STATIONS.
• 8 7/8” DIAMETER
“DWL” STYLE DISC (DWL Disc)
STANDARD WIRE LOOP DISC
• AVAILABLE IN 20 AND 30 STATIONS.
• 1/8” WIRE STATIONS.
“DW” STYLE DISC (DW Disc)
STANDARD NOTCHED TIP DISC
• AVAILABLE WITH 10, 20, AND 30 STATIONS.
• 1/8” WIRE STATIONS
Titanium Racks, Anodizing Clips, and Anodizing Discs
